All MIBs › FC-DS1-MIB
Organization: Lucent Technologies
Last Updated: 240701
Category: Domain: Storage, Fibre Channel and Storage, Vendor: Fibronics (Legacy)
Description: Fibronics (or standards-based) DS1/T1 interface MIB extensions for Fibre Channel or carrier equipment DS1 framing and performance.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is FC-DS1-MIB?
FC-DS1-MIB appears to be a DS1 (T1) interface extension MIB, likely originating from Fibronics or an early carrier/datacom equipment vendor, though the source module description is a generic template placeholder with no vendor-specific detail retained. Such DS1 MIBs typically expose interface configuration (framing, line coding, loopback mode) and performance/error counters (errored seconds, severely errored seconds, unavailable seconds) for T1/E1 circuits. In monitoring terms it would be used to track the physical-layer hardware and line status of DS1 interfaces, such as loss-of-signal alarms and error-second counts, acting as a companion to interface uptime/status monitoring. It would typically extend or align with the IETF DS1/E1 MIB family (RFC 2495/3895) and IF-MIB for ifIndex correlation. It would be deployed on legacy telecom/datacom equipment carrying T1/E1 circuits, such as channel banks, CSU/DSUs, or Fibre Channel-to-DS1 gateway devices. Engineers can download the FC-DS1-MIB file directly to load it into their MIB browser.
IPNetwork Monitor allows you to monitor SNMP objects defined in FC-DS1-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- Lucent Technologies DS1/T1 telecom interface equipment — Identified via the ORGANIZATION field ('Lucent Technologies') and enterprise OID 1751 (Lucent), not Fibronics as previously guessed.
Monitoring Examples
No object or table names were available in the source for this module, so a concrete polling scenario cannot be grounded in real identifiers. Based on the module name and typical DS1 MIB conventions, it would likely expose a DS1 interface configuration/status table indexed by ifIndex with alarm and error-second counters, but this cannot be confirmed from the available data.
Imported Objects
From RFC-1212
| OBJECT-TYPE |
From RFC-1215
| TRAP-TYPE |
From RFC1155-SMI
| Counter | |
| enterprises |
From RFC1213-MIB
| DisplayString |
From SNMPv2-SMI
| Counter32 | |
| Integer32 | |
| MODULE-IDENTITY | |
| ObjectName | |
| snmpModules |
From SNMPv2-TC
| RowStatus | |
| TestAndIncr | |
| TimeStamp | |
| TruthValue |
OIDs
RFC description
Vendor-private or product-specific MIB for managing FC (Fibre Channel) DS1 (Digital Signal Level 1) conversion devices or Fibre Channel-to-DS1 interfaces.
Start monitoring Lucent Technologies DS1/T1 telecom interface equipment with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.