Description: Displays the status of the link to the remote telephone or fax machine.

You cannot modify this object.

Options:

remUnavailable (1): the routing specifies a remote chassis location that does not exist.

remError (2): all voice ports at the specified remote are inactive and therefore cannot accept the call. It is possible that the remote ports are disabled or that the I/O card is not installed.

busy (3): all voice ports at the specified remote are busy and therefore unavailable to accept the call.

open (4): the call was successfully put through to a voice port at the remote location.

errActiveChn (5): the end-user has replaced the receiver (on-hook) at the end of a call and then removed the receiver (off-hook) so quickly that the connection has not had sufficient time to completely disconnect. The end-user should wait a few seconds after replacing the receiver before attempting to place another call.

errPath (6): the Path ID (dialing code) the user entered is not listed in the routing table. Check that the Path ID and routing are completely configured.

errLnk (7): there is an error condition on the line between the local and remote link stations causing the link to be inactive.

fixedLnkDown (8): Memotec use only. Contact Memotec sevice personnel if this value displays.

fixedLnkUp (9): Memotec use only. Contact Memotec service personnel if this value displays.

Default Value: none