| OID symbolic | OID numeric | Type | Access | Description |
|---|
| casaMgmt | 1.3.6.1.4.1.20858.10 | | | |
| casaCmtsCmCpeMib | 1.3.6.1.4.1.20858.10.12 | | | This is the enterprise MIB Module for CASA systems CMTS. |
| casaCmtsCmCpeObjects | 1.3.6.1.4.1.20858.10.12.1 | | | |
| casaCmtsUSModemTable | 1.3.6.1.4.1.20858.10.12.1.1 | | not-accessible | Modem count for each upstream channel. |
| casaCmtsUSModemEntry | 1.3.6.1.4.1.20858.10.12.1.1.1 | | not-accessible | Index of the table is logical uptream channel ifIndex . |
| U32 casaCmtsUSActiveModemCount | 1.3.6.1.4.1.20858.10.12.1.1.1.1 | Unsigned32 | read-only | Active modem count for each upstream channel. |
| U32 casaCmtsUSRegisteredModemCount | 1.3.6.1.4.1.20858.10.12.1.1.1.2 | Unsigned32 | read-only | Registered modem count for each upstream channel. |
| U32 casaCmtsUSTotalModemCount | 1.3.6.1.4.1.20858.10.12.1.1.1.3 | Unsigned32 | read-only | Modem total for each upstream channel. |
| casaCmtsDSModemTable | 1.3.6.1.4.1.20858.10.12.1.2 | | not-accessible | Modem count for each downstream channel. |
| casaCmtsDSModemEntry | 1.3.6.1.4.1.20858.10.12.1.2.1 | | not-accessible | Index of the table is downstream channel ifIndex . |
| U32 casaCmtsDSActiveModemCount | 1.3.6.1.4.1.20858.10.12.1.2.1.1 | Unsigned32 | read-only | Active modem count for each downstream channel. |
| U32 casaCmtsDSRegisteredModemCount | 1.3.6.1.4.1.20858.10.12.1.2.1.2 | Unsigned32 | read-only | Registered modem count for each downstream channel. |
| U32 casaCmtsDSTotalModemCount | 1.3.6.1.4.1.20858.10.12.1.2.1.3 | Unsigned32 | read-only | Modem total for each downstream channel. |
| casaCmtsCmCpeTable | 1.3.6.1.4.1.20858.10.12.1.3 | | not-accessible | Describes the relation between CPE and CM. |
| casaCmtsCmCpeEntry | 1.3.6.1.4.1.20858.10.12.1.3.1 | | not-accessible | The list contains information for a cable modem (CM) or a
Customer Premises Equipment (CPE). An entry exist for
each cable modem supported by CMTS and each Customer
Premises Equipment connected to a cable modem supported by
CMTS. |
| MAC casaCmtsCmCpeMacAddress | 1.3.6.1.4.1.20858.10.12.1.3.1.1 | MacAddress | not-accessible | The Mac address to identify a cable modem or a Customer
Premises Equipment. |
| INT casaCmtsCmCpeType | 1.3.6.1.4.1.20858.10.12.1.3.1.2 | INTEGER | read-only | ndicate this entry is for cable modem or Customer Premises
Equipment. The enumerations are:
cm(1): cable modem
cpe(2): Customer Premises Equipment |
| IP casaCmtsCmCpeIpAddress | 1.3.6.1.4.1.20858.10.12.1.3.1.3 | IpAddress | read-only | Ip address of the cable modem or Customer Premises
Equipment. |
| NUM casaCmtsCmCpeIfIndex | 1.3.6.1.4.1.20858.10.12.1.3.1.4 | InterfaceIndex | read-only | The CMTS cable MAC interface index (ifType of
docsCableMaclayer(127)) that cable modem or Customer
Premises Equipment connects to.
Use casaCmtsCmCpeIfIndex and casaCmtsCmCpeCmtsServiceId to identify
an entry in docsIfCmtsServiceTable. |
| I32 casaCmtsCmCpeCmtsServiceId | 1.3.6.1.4.1.20858.10.12.1.3.1.5 | Integer32 | read-only | The cable modem's primary Service ID if the type is cm.
The primary Service ID for the CM which the CPE connects if
the type is cpe.
Use casaCmtsCmCpeIfIndex and casaCmtsCmCpeCmtsServiceId to identify
an entry in docsIfCmtsServiceTable. |
| I32 casaCmtsCmCpeCmStatusIndex | 1.3.6.1.4.1.20858.10.12.1.3.1.6 | Integer32 | read-only | Pointer to an entry in docsIfCmtsCmStatusTable identifying
status of the CM (which the CPE connects to.) |
| T/F casaCmtsCmCpeResetNow | 1.3.6.1.4.1.20858.10.12.1.3.1.7 | TruthValue | read-write | Setting this object to true(1) causes the device to
reset. Reading this object always returns false(2).
For casaCmtsCmCpeType value cm(1), CMTS removes the
CM from the Station Maintenance List and would cause
the CM to reset its interface.
For casaCmtsCmCpeType value cpe(2), CMTS removes the
CPE's MAC address from the internal address table.
It then rediscovers and associates the CPE with the
correct CM during the next DHCP lease cycle. By resetting
the CPE, the user can replace an existing CPE or change
its network interface card (NIC) |
| casaCmtsCpeIpNetToPhysicalTable | 1.3.6.1.4.1.20858.10.12.1.4 | | not-accessible | The IP Address Translation table used for mapping from IP
addresses to physical addresses. |
| casaCmtsCpeIpNetToPhysicalEntry | 1.3.6.1.4.1.20858.10.12.1.4.1 | | not-accessible | Each entry contains one IP address to `physical' address
equivalence.. |
| NUM casaCmtsCpeIpNetToPhysicalIfIndex | 1.3.6.1.4.1.20858.10.12.1.4.1.1 | InterfaceIndex | not-accessible | The index value that uniquely identifies the interface to
which this entry is applicable. The interface identified by
a particular value of this index is the same interface as
identified by the same value of the IF-MIB's ifIndex. |
| IPt casaCmtsCpeIpNetToPhysicalNetAddressType | 1.3.6.1.4.1.20858.10.12.1.4.1.2 | InetAddressType | not-accessible | The type of casaCmtsCpeIpNetToPhysicalNetAddress. |
| IP casaCmtsCpeIpNetToPhysicalNetAddress | 1.3.6.1.4.1.20858.10.12.1.4.1.3 | InetAddress | not-accessible | The IP Address corresponding to the media-dependent
`physical' address. The address type of this object is
specified in casaCmtsCpeIpNetToPhysicalAddressType. |
| PHY casaCmtsCpeIpNetToPhysicalCmPhysAddress | 1.3.6.1.4.1.20858.10.12.1.4.1.5 | PhysAddress | read-only | The CM MAC address. |
| INT casaCmtsCpeIpNetToPhysicalType | 1.3.6.1.4.1.20858.10.12.1.4.1.7 | INTEGER | read-only | The type of mapping.
Setting this object to the value invalid(2) has the effect
of invalidating the corresponding entry in the
ipNetToPhysicalTable. That is, it effectively dis-
associates the interface identified with said entry from the
mapping identified with said entry. It is an
implementation-specific matter as to whether the agent
removes an invalidated entry from the table. Accordingly,
management stations must be prepared to receive tabular
information from agents that corresponds to entries not
currently in use. Proper interpretation of such entries
requires examination of the relevant ipNetToPhysicalType
object.
The 'dynamic(3)' type indicates that the IP address to
physical addresses mapping has been dynamically resolved
using e.g., IPv4 ARP or the IPv6 Neighbor Discovery
protocol.
The 'static(4)' type indicates that the mapping has been
statically configured. Both of these refer to entries that
provide mappings for other entities addresses.
The 'local(5)' type indicates that the mapping is provided
for an entity's own interface address.
As the entries in this table are typically not persistent
when this object is written the entity SHOULD NOT save the
change to non-volatile storage. |
| casaCmtsCmReset | 1.3.6.1.4.1.20858.10.12.1.5 | | | |
| IP casaCmtsCmResetByIpAddr | 1.3.6.1.4.1.20858.10.12.1.5.1 | IpAddress | read-write | to reset cable modem by ip address |
| MAC casaCmtsCmResetByMacAddr | 1.3.6.1.4.1.20858.10.12.1.5.2 | MacAddress | read-write | to reset cable modem by mac address |
| T/F casaCmtsCmResetAll | 1.3.6.1.4.1.20858.10.12.1.5.3 | TruthValue | read-write | If set to 'true', all cable modem are reset. Reading this object always returns
'false'. |
| casaCmCpeGroups | 1.3.6.1.4.1.20858.10.12.2 | | | |
| casaCmCpeGroup | 1.3.6.1.4.1.20858.10.12.2.1 | | | Description. |
| casaCmCpeCompliances | 1.3.6.1.4.1.20858.10.12.3 | | | |
| casaCmCpeCompliance | 1.3.6.1.4.1.20858.10.12.3.1 | | | Description. |
