Description: The Maintenance Association End Point (MEP) performance measurement operation table stores all the managed objects for sending DMM.

Steps to use entries in this table:

1) Wait for zxAnCfm2MepDmEnable value to be disabled. To do this do this sequence: a. an SNMP GET for both snmpSetSerialNo and zxAnCfm2MepDmEnable objects (in same SNMP PDU). b. Check if value for zxAnCfm2MepDmEnable is disabled. - if not, wait x seconds, go to step a above. - if enabled, save the value of snmpSetSerialNo and go to step 2) below 2) Change zxAnCfm2MepDmEnable value from disabled to enabled to ensure no other management entity will use the service. In order to not disturb a possible other NMS do this by sending an SNMP SET for both snmpSetSerialNo and zxAnCfm2MepDmEnable and other delay measurement objects (such as zxAnCfm2MepDmPriority,...) (in same SNMP PDU, and make sure snmpSetSerialNo is the first varbind). For the snmpSetSerialNo varbind, use the value that you obtained in step 1) a. This ensures that two cooperating NMSes will not step on each others toes. 3) Check the value of zxAnCfm2MepDmResultOk to find out if the operation was successfully initiated or not. 4) Monitor the value of zxAnCfm2MepDmEnable. When it is reset to false, the last DMM has been transmitted. 5) Get the results of the test from zxAnCfm2MepDmRltTable.