Select a Spring Tide Networks broadband aggregation equipment as the target host to create a monitor — the SNMP service should be up and running on it. Click New Monitor, then check SNMP Custom on the Favorites tab, click Next, and confirm the host. On the next page, click Select... to open the built-in SNMP MIB Browser and type stnPmClassStatsHighWater into the Find box to locate it in the OID tree, then select it and click OK. The historical maximum number of packets that were queued for this class since the system was last reinitialized. On the monitor's Main parameters page you can set the target's SNMP port (default 161), credentials, polling interval, and other settings — see the SNMP Monitor help for details. On the State conditions and Alerting tabs, configure when the monitor should change state and trigger an alert; since this is a Counter32-type OID, Value bounds is the most useful condition here — trigger an alert if the value climbs close to a level you consider a practical ceiling for this device, since a rising peak often signals sustained load growth worth planning capacity around. Click Finish to create the monitor; you can adjust any parameter later.