All MIBs › RADIO-BRIDGE-MIB › rfLoopModeSelector
rfLoopModeSelector
Module: RADIO-BRIDGE-MIB
OID (symbolic): RADIO-BRIDGE-MIB::rfLoopModeSelector
OID (numeric): 1.3.6.1.4.1.31926.2.1.1.36
Node type: OBJECT-TYPE
Type: INTEGER
Access: read-write
What is rfLoopModeSelector?
Configures a diagnostic loopback on this RF interface: rfLoopDisabled(1) for normal operation or rfLoopInternalMacSwap(2) to loop traffic back internally with MAC addresses swapped. Technicians enable this during installation or fault isolation to test the link without needing traffic from the far end.
Examples
Walk all instances (SNMPv2c):
snmpwalk -v2c -c public <target> 1.3.6.1.4.1.31926.2.1.1.36 snmpwalk -v2c -c public <target> RADIO-BRIDGE-MIB::rfLoopModeSelector
Get a specific instance (index 1):
snmpget -v2c -c public <target> 1.3.6.1.4.1.31926.2.1.1.36.1 snmpget -v2c -c public <target> RADIO-BRIDGE-MIB::rfLoopModeSelector.1
Set instance 1 (SNMPv2c):
snmpset -v2c -c private <target> 1.3.6.1.4.1.31926.2.1.1.36.1 i <value>
Start monitoring microwave radio bridge link unit with a free 30-day trial of IPNetwork Monitor. Create custom SNMP monitor using the RADIO-BRIDGE-MIB::rfLoopModeSelector OID value, configure state conditions and alerts, and monitor any microwave radio bridge link unit from a single console.
OID Breakdown
Upper-level ancestors (6 from the standard OID tree / other modules)
| Numeric OID | Name | Module |
|---|---|---|
| 1 | iso | LANART-AGENT |
| 1.3 | org | AirPair-MIB |
| 1.3.6 | dod | AirPair-MIB |
| 1.3.6.1 | internet | AirPair-MIB |
| 1.3.6.1.4 | private | AirPair-MIB |
| 1.3.6.1.4.1 | enterprises | AirPair-MIB |
| Numeric OID | Name | Module |
|---|---|---|
| 1.3.6.1.4.1.31926 | radioBridgeRoot | RADIO-BRIDGE-MIB |
| 1.3.6.1.4.1.31926.2 | radioBridgeRf | RADIO-BRIDGE-MIB |
| 1.3.6.1.4.1.31926.2.1 | rbRfTable | RADIO-BRIDGE-MIB |
| 1.3.6.1.4.1.31926.2.1.1 | rbRfEntry | RADIO-BRIDGE-MIB |
| 1.3.6.1.4.1.31926.2.1.1.36 | rfLoopModeSelector | RADIO-BRIDGE-MIB |