All MIBs › PRVT-MPLS-TE-MIB › mplsTunnelTable
mplsTunnelTable
Module: PRVT-MPLS-TE-MIB
OID (symbolic): PRVT-MPLS-TE-MIB::mplsTunnelTable
OID (numeric): 1.3.6.1.4.1.738.1.6.5.2.1.2
Node type: OBJECT-TYPE
Access: not-accessible
Description: The mplsTunnelTable allows new MPLS tunnels to be created between an LSR and a remote endpoint, and existing tunnels to be reconfigured or removed. Note that only point-to-point tunnel segments are supported, although multi-point-to-point and point- to-multi-point connections are supported by an LSR acting as a cross-connect. Each MPLS tunnel can thus have one out-segment originating at this LSR and/or one in-segment terminating at this LSR.
To configure tunnels where the ingress and egress routers are identified by IPv6 addresses, the following approach is used.
- The mplsTunnelIngressLSRId and mplsTunnelEgressLSRId fields are set to 32-bit identifiers for the ingress and egress routers.
- mplsTunnelHopTableIndex must be set to a non-zero value.
- The first hop in the hop table for the tunnel path must be set to a global scope IPv6 address of the local router.
- The last entry in the hop table must be set to a global scope IPv6 address of the egress router.
OID Breakdown
Upper-level ancestors (10 from the standard OID tree / other modules)
| Numeric OID | Name | Module |
|---|---|---|
| 1 | iso | LANART-AGENT |
| 1.3 | org | AirPair-MIB |
| 1.3.6 | dod | AirPair-MIB |
| 1.3.6.1 | internet | AirPair-MIB |
| 1.3.6.1.4 | private | AirPair-MIB |
| 1.3.6.1.4.1 | enterprises | AirPair-MIB |
| 1.3.6.1.4.1.738 | privateVendorOID | PRIV-VENDORDEF-MIB |
| 1.3.6.1.4.1.738.1 | prvt_products | PRVT-SWITCH-MIB |
| 1.3.6.1.4.1.738.1.6 | ipSwitch | PRVT-SWITCH-MIB |
| 1.3.6.1.4.1.738.1.6.5 | mpls | PRVT-CR-LDP-MIB |
| Numeric OID | Name | Module |
|---|---|---|
| 1.3.6.1.4.1.738.1.6.5.2 | mplsTeMIB | PRVT-MPLS-TE-MIB |
| 1.3.6.1.4.1.738.1.6.5.2.1 | mplsTeObjects | PRVT-MPLS-TE-MIB |
| 1.3.6.1.4.1.738.1.6.5.2.1.2 | mplsTunnelTable | PRVT-MPLS-TE-MIB |