All MIBs › JUNIPER-LSYSSP-NATSRCNOPATAD-MIB
Organization: Juniper Networks, Inc.
Last Updated: 2010-05-19
Category: Vendor: Juniper
Description: Defines managed objects for NAT source no-PAT address resource limits per logical system security profile on Juniper Networks SRX devices.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is JUNIPER-LSYSSP-NATSRCNOPATAD-MIB?
JUNIPER-LSYSSP-NATSRCNOPATAD-MIB is another Juniper LSYS security-profile MIB, focused on NAT source no-PAT (no Port Address Translation) address resource limits per logical system on SRX devices—tracking a pool of source addresses reserved for one-to-one NAT without port translation. It exposes resource-quota configuration and current usage of no-PAT source-NAT addresses per logical system. It is used to monitor address-pool capacity for this specialized NAT mode—detecting when a logical system's no-PAT address allocation is close to exhausted, a resource-capacity health signal rather than physical hardware status. It is a sibling to the other Juniper LSYSSP resource MIBs (flow-session, scheduler, secure-wire), forming a family that models different quota types within the LSYS security-profile framework. It is typically deployed in multi-tenant Juniper SRX environments performing no-PAT source NAT per logical system, common in service-provider or large enterprise setups, where the JUNIPER-LSYSSP-NATSRCNOPATAD-MIB MIB tracks how close each logical system is to exhausting its no-PAT address quota.
IPNetwork Monitor allows you to monitor SNMP objects defined in JUNIPER-LSYSSP-NATSRCNOPATAD-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- Juniper Networks SRX security devices (logical systems/multi-tenant deployments)
Monitoring Examples
No object names were supplied in the sample data, but based on the module's stated purpose an admin would expect a table showing configured no-PAT address quota versus addresses currently allocated per logical system, useful for catching a tenant approaching exhaustion of its dedicated no-PAT address pool before new one-to-one NAT mappings start failing.
What Can Be Monitored
- no-PAT NAT address quota
- current no-PAT address usage
- per-logical-system NAT resource allocation
Imported Objects
From JUNIPER-LSYS-SECURITYPROFILE-MIB
| jnxLsysSpNATsrcnopatad | OBJECT-IDENTITY |
From SNMPv2-SMI
| MODULE-IDENTITY | |
| NOTIFICATION-TYPE | |
| OBJECT-TYPE | |
| Unsigned32 |
From SNMPv2-TC
| DisplayString |
OIDs
RFC description
Juniper Networks logical systems MIB for NAT source no-PAT address management; vendor-private MIB for managing NAT address translation policies.
Start monitoring Juniper SRX security device (logical-system NAT no-PAT source-address quota) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.