Select an Enterasys Networks switch (legacy, later Extreme Networks) (concurrent 802.1X/PWA/MAC/CEP authentication) as the target host to create a monitor — the SNMP service should be up and running on it. Click New Monitor, then check SNMP Custom on the Favorites tab, click Next, and confirm the host. On the next page, click Select... to open the built-in SNMP MIB Browser and type etsysMultiAuthSystemCurrentNumUsers into the Find box to locate it in the OID tree, then select it and click OK. The current number of users the are actively authenticated, have authentications in progress, or the device is keeping authentication termination information for in the system. On the monitor's Main parameters page you can set the target's SNMP port (default 161), credentials, polling interval, and other settings — see the SNMP Monitor help for details. On the State conditions and Alerting tabs, configure when the monitor should change state and trigger an alert; since this is a Gauge32-type OID, Value bounds is the most useful condition here — trigger an alert if the counter increases sharply between polls relative to its normal baseline, since an unexpected spike often reflects a real change in traffic or activity. Click Finish to create the monitor; you can adjust any parameter later.