DES3200-28F-L3MGMT-MIB

Description: Manages L3 routing and IP interfaces for D-Link DES-3200-28F fiber switch.

Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.

This is a D-Link enterprise MIB module that manages Layer 3 routing and IP interface functions for the DES-3200-28F fiber Ethernet switch. It exposes configuration-oriented data covering IP interface assignment, routing table entries, and Layer 3 forwarding parameters for the switch's fiber ports. Administrators use it mainly to confirm routing configuration and interface reachability rather than to pull hardware sensors, though it is normally polled alongside other D-Link management MIBs that report chassis, power, and fan status for a complete health picture. It builds on the standard D-Link enterprise MIB tree and typically depends on companion D-Link MIBs (general management, Layer 2 MIBs) for full device coverage. It is deployed in access/aggregation networks using D-Link DES-3200-28F fiber switches where basic Layer 3 routing is required at the edge. Engineers can download the DES3200-28F-L3MGMT-MIB file directly to load it into their MIB browser.

No object or table names were captured in the extracted sample for this module, so specific identifiers cannot be cited here. Based on its description, an admin would typically poll IP interface assignment and routing table entries on the DES-3200-28F's Layer 3 ports to verify configured routes and interface addresses match the intended network design. A missing or unexpected route entry, or an interface reporting the wrong IP configuration, would indicate a Layer 3 misconfiguration affecting connectivity.

D-Link DES3200 Layer 3 network management MIB for IPv4/IPv6 interface and DHCP configuration.