The fault group associated with the override behavior. When an event occurs that would normally trigger a card reset and a sparing event and that event is in the configured fault group, the mode configured in the cerCard table is overriden.

pingFault - Communications failure with active controller initTimeout - Timeout during card initialization ersmFault - Card ERSM failure swException - Software exception failure bcm3142Err - Upstream CAM PHY device fatal fault condition dulFailure - Upstream CAM periodic packet loop detected uncorrectable fault dataplaneFailrue - Fatal errors originating in dataplane processor dsUnderPower - Downstream CAM detected power on a connector is below operational threshold dsOverPower - Downstream CAM detected power on a connector is above operational threshold sbecOverflow - Excessive number of single bit ECC errors deviceFatal - General device fatal error. For example in internal datapaths or pci controller. fpgaFatalError - Fatal CRC errors detected in FPGA device clockLost - Loss of clock or loss of clock lock pwrSensorHighFault - Detected voltage is above operational threshold pwrSensorLowFault - Detected voltage is below operational threshold fpgaBufferPoolFault - Number of available buffers in MAC fpga is below threshold dataplaneLinkFault - Card has lost dataplane connectivity monitoredTaskFailure - Monitored software task has failed