All MIBs › C-PRODUCT-BASE-L-SPECIFIC
Category: Hardware Inventory
Description: Defines layer-specific base management objects for a C-PRODUCT series network platform.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is C-PRODUCT-BASE-L-SPECIFIC?
C-PRODUCT-BASE-L-SPECIFIC is a vendor-specific MIB module defining layer-specific base management objects for a device referred to generically as the "C-PRODUCT" series network platform (the naming suggests a genericized/rebranded legacy network device, likely Cabletron or similar). It exposes system-level configuration data including software/code release and bank information as well as low-level IP configuration objects for local host addressing (including SLIP interface settings). In monitoring terms it supports checking software version and code-bank status on the device -- useful for confirming which firmware image is active and standby -- as well as verifying basic IP configuration correctness on management interfaces. It is a proprietary base MIB likely paired with sibling MIBs (such as module-specific ones like C-PRODUCT-QSIM-MIB) that extend it for particular interface cards. It would typically be deployed on legacy modular chassis-based network switches/routers using dual-bank firmware architecture. Engineers can download the C-PRODUCT-BASE-L-SPECIFIC file directly to load it into their MIB browser.
IPNetwork Monitor allows you to monitor SNMP objects defined in C-PRODUCT-BASE-L-SPECIFIC. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- legacy modular chassis network switch/router (C-PRODUCT series)
Monitoring Examples
An administrator would poll sysGenStandbyCodeRelease and sysGenSwitchCodeBank to confirm which firmware release is staged as the standby image and which code bank is currently active, which matters when validating a firmware upgrade or preparing a bank switchover. sysIpConfigLocalHostSlipAddress and sysIpConfigLocalHostSlipSubnetMask would be checked to verify the device's local SLIP-based management interface is configured with the expected address and mask. Discrepancies here would surface as an inability to reach the device's management plane over its serial link.
What Can Be Monitored
- active/standby firmware code release
- code bank selection
- local host SLIP IP address
- local host SLIP subnet mask
Imported Objects
From C-PRODUCT-BASE-MIB
| sysGenInfo | OBJECT-IDENTITY |
| sysIpConfigLocalHost | OBJECT-IDENTITY |
From RFC-1212
| OBJECT-TYPE |
From RFC1155-SMI
| IpAddress |
From RFC1213-MIB
| DisplayString |
OIDs
RFC description
Device-specific firmware and code configuration for PBS700 managed devices.
Start monitoring Networking equipment with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.