The value of tmnxDS1BerSfThreshold specifies a bit error rate (BER)
threshold used to determine when to send a tmnxEqPortDS1Alarm 
notification for a BER SF failure and a tmnxEqPortDS1AlarmClear
notification for a BER SF failure clear. Bit error computed must 
reach/exceed threshold value over a pre-defined period of time
for the tmnxEqPortSonetAlarm notification to be sent.

The value of tmnxDS1Framing defines how the bit errors are
computed and what values of tmnxDS1BerSfThreshold are allowed.
The following table defines this dependency:

tmnxDS1Framing   Bit error calculation and value supported
--------------   -----------------------------------------
  esf  (1)       each CRC error is counted as one bit error
  g704 (4)       values supported are 1,5,10,50,100
   
  other values   bit error alarms not supported, value
                 of tmnxDS1BerSfThreshold set to default and 
                 cannot be changed
        
tmnxDS1BerSfThreshold value must not be smaller than 
tmnxDS1BerSdThreshold value