All MIBs › XYLO-WAN-MIB › anxt1UpTime
anxt1UpTime
Module: XYLO-WAN-MIB
OID (symbolic): XYLO-WAN-MIB::anxt1UpTime
OID (numeric): 1.3.6.1.4.1.15.2.11.2.1.11
Node type: OBJECT-TYPE
Type: INTEGER
Access: read-only
Description: Indicates the up time in minutes for the T1 engine. Doing a hard reset will reset this value. Note: This value may not be same as sysupTime if a hard reset has been done at any time after the annex is brought up. This object is supported for T1 modules only.
Examples
Walk all instances (SNMPv2c):
snmpwalk -v2c -c public <target> 1.3.6.1.4.1.15.2.11.2.1.11 snmpwalk -v2c -c public <target> XYLO-WAN-MIB::anxt1UpTime
Get a specific instance (index 1):
snmpget -v2c -c public <target> 1.3.6.1.4.1.15.2.11.2.1.11.1 snmpget -v2c -c public <target> XYLO-WAN-MIB::anxt1UpTime.1
Start monitoring Xylogics (Bay Networks) Annex remote-access servers (T1/PRI line framing/signaling config status) with a free 30-day trial of IPNetwork Monitor. Create custom SNMP monitor using the XYLO-WAN-MIB::anxt1UpTime OID value, configure state conditions and alerts, and monitor any Xylogics (Bay Networks) Annex remote-access servers (T1/PRI line framing/signaling config status) from a single console.
OID Breakdown
Upper-level ancestors (9 from the standard OID tree / other modules)
| Numeric OID | Name | Module |
|---|---|---|
| 1 | iso | LANART-AGENT |
| 1.3 | org | AirPair-MIB |
| 1.3.6 | dod | AirPair-MIB |
| 1.3.6.1 | internet | AirPair-MIB |
| 1.3.6.1.4 | private | AirPair-MIB |
| 1.3.6.1.4.1 | enterprises | AirPair-MIB |
| 1.3.6.1.4.1.15 | xylogics | ANNEX-MIB |
| 1.3.6.1.4.1.15.2 | annex | ANNEX-MIB |
| 1.3.6.1.4.1.15.2.11 | anxt1 | XYLO-MIB-SMI |
| Numeric OID | Name | Module |
|---|---|---|
| 1.3.6.1.4.1.15.2.11.2 | anxt1ConfigT1Table | XYLO-WAN-MIB |
| 1.3.6.1.4.1.15.2.11.2.1 | anxt1ConfigT1Entry | XYLO-WAN-MIB |
| 1.3.6.1.4.1.15.2.11.2.1.11 | anxt1UpTime | XYLO-WAN-MIB |