Description: This persistent variable controls whether the Agent will attempt to sent a trap to the specific manager, depending upon other controls (or filters).

If these conditions are met, then the Agent will attempt to send an SNMP trap, to this manager, at which time it will increment 'trapMgrCounter'.

If this variable, 'trapMgrControl' is set to 'both', then this Agent will send both enterprise and standard traps to this manager.

If this variable, 'trapMgrControl' is set to 'standard', then this Agent will send only standard traps to this manager.

If this variable, 'trapMgrControl' is set to 'enterprise', then this Agent will send only enterprise traps to this manager.

This variable, may only be set when 'trapMgrAddress' has an IP address other than '0.0.0.0'.

If this variable, is set to 'none', then this manager will never be sent a trap from this Agent. This is the default value.

The Agent determines if a trap can be sent by examining several controls (or filters), all of which enable the sending of the trap. These are described in their order of checking below:

One, the MIB variable that enables that specific trap to be sent is enabled. (Each trap can be selectively enabled or disabled.) If a trap is not sent due to this filter, then 'trapFilteredSpecific' is incremented.

Two, the MIB 'trapControl', is set to 'unLimited'; or, it is set to 'feedbackPinLimited' and 'trapFlow' is set to 'open'. If a trap is not sent due to this filter, then 'trapFilteredControl' is incremented.

Three, one or more trap managers must be defined in the table 'trapMgrTable' with a valid IP address in 'trapMgrTable.trapMgrAddress', and their control variable 'trapMgrTable.trapMgrControl' must be configured to 1) 'both' or 'standard' and the trap is a standard trap; or 2) 'enterprise' or 'both', and the trap is an enterprise trap. If a trap is not sent due to this filter, then 'trapFilteredManager' is incremented.

Four, the trap has no associated severity level, or the severity level of the trap is equal or higher than the value specified by the severity filter 'trapSeverityFilter'. If a trap is not sent due to this filter, then 'trapFilteredSeverity' is incremented.