VDSL2-LINE-MIB :: xdsl2LineStatusElectricalLength

MIB Reference — IPNetwork Monitor · Updated October 06, 2026

All MIBs › VDSL2-LINE-MIB › xdsl2LineStatusElectricalLength

xdsl2LineStatusElectricalLength

Module: VDSL2-LINE-MIB

OID (symbolic): VDSL2-LINE-MIB::xdsl2LineStatusElectricalLength

OID (numeric): 1.3.6.1.2.1.10.251.1.1.1.1.31

Node type: OBJECT-TYPE

Type: Unsigned32

Access: read-only

Description: This parameter contains the estimated electrical length expressed in dB at 1 MHz, kl0. This is the final electrical length that would have been sent from the VTU-O to VTU-R if the electrical length was not forced by the CO-MIB. The value ranges from 0 to 128 dB in steps of 0.1 dB.

What is xdsl2LineStatusElectricalLength?

Reports the line's estimated electrical length (kl0) at 1 MHz, in units of 0.1 dB (0 to 1280, i.e. 0 to 128 dB), the final value used if it wasn't overridden by the operator's CO-side configuration. This is effectively a proxy for copper loop length/quality, so an admin uses it to spot unusually long or degraded loops when triaging a low-sync-rate complaint.

Examples

Walk all instances (SNMPv2c):

snmpwalk -v2c -c public <target> 1.3.6.1.2.1.10.251.1.1.1.1.31
snmpwalk -v2c -c public <target> VDSL2-LINE-MIB::xdsl2LineStatusElectricalLength

Get a specific instance (index 1):

snmpget -v2c -c public <target> 1.3.6.1.2.1.10.251.1.1.1.1.31.1
snmpget -v2c -c public <target> VDSL2-LINE-MIB::xdsl2LineStatusElectricalLength.1

Start monitoring vendor-neutral, standards-based MIB, DSL access multiplexers (DSLAMs), VDSL2/ADSL modems and routers (line up/down/template/diagnostic status) with a free 30-day trial of IPNetwork Monitor. Create custom SNMP monitor using the VDSL2-LINE-MIB::xdsl2LineStatusElectricalLength OID value, configure state conditions and alerts, and monitor any vendor-neutral, standards-based MIB, DSL access multiplexers (DSLAMs), VDSL2/ADSL modems and routers (line up/down/template/diagnostic status) from a single console.

OID Breakdown

Upper-level ancestors (7 from the standard OID tree / other modules)
Numeric OIDNameModule
1isoLANART-AGENT
1.3orgAirPair-MIB
1.3.6dodAirPair-MIB
1.3.6.1internetAirPair-MIB
1.3.6.1.2mgmtAPERTUS-NPG-MIB
1.3.6.1.2.1mib_2AXON-MIB
1.3.6.1.2.1.10transmissionCHECKPOINT-MIB-2
Numeric OIDNameModule
1.3.6.1.2.1.10.251vdsl2MIBVDSL2-LINE-MIB
1.3.6.1.2.1.10.251.1xdsl2ObjectsVDSL2-LINE-MIB
1.3.6.1.2.1.10.251.1.1xdsl2LineVDSL2-LINE-MIB
1.3.6.1.2.1.10.251.1.1.1xdsl2LineTableVDSL2-LINE-MIB
1.3.6.1.2.1.10.251.1.1.1.1xdsl2LineEntryVDSL2-LINE-MIB
1.3.6.1.2.1.10.251.1.1.1.1.31xdsl2LineStatusElectricalLengthVDSL2-LINE-MIB