Description: Each entry refers to a probe, and consists of the various essential parameters for it: the probe identifier, the address of the page where the probe must be initially connected in order to initiate the speed measuring process, the type of periodicity and the value of the period the probe boots with, the minimum access speed value below which the measurement is taken into account in order to generate an SNMP event (TRAP) 'Threshold not reached', the number of consecutive measurements that must be produced with the speed below the configured threshold so this SNMP TRAP is generated, a variable to indicate if the SNMP TRAP 'Threshold not reached' is enabled, a variable to delete the probe, another variable to indicate the timeout configured for this probe and the kind of page to request. To add or configure a new probe is enough to use the following index to the last existing probe identifier in the corresponding SET operation, but there is a maximum number of configured probes that must be respected.