All MIBs › SW3x50PRIMGMT-MIB
Category: Switch Management - D-Link
Description: Manages primary configuration and status objects specific to the D-Link DES-3x50 switch series.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is SW3x50PRIMGMT-MIB?
SW3x50PRIMGMT-MIB is a vendor-specific SNMP module for D-Link's DES-3x50 series managed Ethernet switches, covering the primary management and configuration layer of the device. It exposes objects for system-level configuration state and general switch status rather than deep per-protocol counters. As a management MIB for a fixed-configuration access switch, it is used to check that the switch is reachable and correctly configured, effectively confirming basic software/hardware health such as whether the unit is responding and its configuration is in the expected state. No module description or sample object list was available for this MIB, so its exact object set could not be confirmed from source. It would typically be polled from a legacy network management station alongside standard IF-MIB and SNMPv2-MIB objects for basic availability monitoring of small workgroup switches. Engineers can download the SW3x50PRIMGMT-MIB file directly to load it into their MIB browser.
IPNetwork Monitor allows you to monitor SNMP objects defined in SW3x50PRIMGMT-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- D-Link DES-3x50 series managed Ethernet switch
Monitoring Examples
No sample objects were provided in the source data for this MIB, so a concrete polling example referencing real object names cannot be given honestly. In general, a management MIB of this kind would be used to read back the switch's active configuration parameters to confirm they match the intended state after a change. Because the object list is unknown, administrators would need to consult the actual MIB file or a MIB browser to identify pollable leaf nodes before building monitoring around it.
Imported Objects
From DLINK-ID-REC-MIB
| dlink-mgmt | |
| dlink-products |
From SNMPv2-SMI
| MODULE-IDENTITY |
OIDs
RFC description
Product registration MIB for D-Link DES-3x50 series switches. Defines OIDs for device units, modules, and port types.
Start monitoring D-Link DES-3x50 series managed Ethernet switch (primary management config) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.