Select an Ericsson Diax IP DSLAM, DSL access multiplexer (subscriber ADSL interface ports) as the target host to create a monitor — the SNMP service should be up and running on it. Click New Monitor, then check SNMP Custom on the Favorites tab, click Next, and confirm the host. On the next page, click Select... to open the built-in SNMP MIB Browser and type adslIfSpeed into the Find box to locate it in the OID tree, selecting the specific row/instance you want to monitor since this is a table column, then select it and click OK. It reports an estimate of the interface's current bandwidth in bits per second. On the monitor's Main parameters page you can set the target's SNMP port (default 161), credentials, polling interval, and other settings — see the SNMP Monitor help for details. On the State conditions and Alerting tabs, configure when the monitor should change state and trigger an alert; since this is a Gauge32-type OID, Value bounds is the most useful condition here — trigger an alert if the rate climbs well above its normal baseline (in bits per second), since a sustained spike often reflects real load growth or a runaway process. Click Finish to create the monitor; you can adjust any parameter later.