PDN-MPE-HEALTH-AND-STATUS-MIB :: mpeDevSelfTestResults

MIB Reference — IPNetwork Monitor · Updated October 06, 2026

All MIBs › PDN-MPE-HEALTH-AND-STATUS-MIB › mpeDevSelfTestResults

mpeDevSelfTestResults

Module: PDN-MPE-HEALTH-AND-STATUS-MIB

OID (symbolic): PDN-MPE-HEALTH-AND-STATUS-MIB::mpeDevSelfTestResults

OID (numeric): 1.3.6.1.4.1.1795.2.24.12.7.1.1.1.1

Node type: OBJECT-TYPE

Type: DisplayString

Access: read-only

Description: Self-test results. Self-test (or power-up test) results summarizes the test results of each CCA, where each CCA test result is separated by a semi-colon. Refer to device-specific user documentation for a complete description of the self test codes and messages.

What is mpeDevSelfTestResults?

This string reports the results of the device's power-up self-test, with results for each internal circuit card assembly (CCA) concatenated together and separated by semicolons. An administrator reads this value after a reboot or on-demand diagnostic run to confirm every hardware module passed its self-check, consulting vendor documentation to decode any specific failure codes shown. For example, the value might read "CCA1:PASS;CCA2:PASS;CCA3:FAIL-0x04" indicating a fault was detected on the third card.

Examples

Walk all instances (SNMPv2c):

snmpwalk -v2c -c public <target> 1.3.6.1.4.1.1795.2.24.12.7.1.1.1.1
snmpwalk -v2c -c public <target> PDN-MPE-HEALTH-AND-STATUS-MIB::mpeDevSelfTestResults

Get a specific instance (index 1):

snmpget -v2c -c public <target> 1.3.6.1.4.1.1795.2.24.12.7.1.1.1.1.1
snmpget -v2c -c public <target> PDN-MPE-HEALTH-AND-STATUS-MIB::mpeDevSelfTestResults.1

Start monitoring Paradyne Multi-Port Ethernet (MPE) module (hardware health/self-test) with a free 30-day trial of IPNetwork Monitor. Create custom SNMP monitor using the PDN-MPE-HEALTH-AND-STATUS-MIB::mpeDevSelfTestResults OID value, configure state conditions and alerts, and monitor any Paradyne Multi-Port Ethernet (MPE) module (hardware health/self-test) from a single console.

OID Breakdown

Upper-level ancestors (11 from the standard OID tree / other modules)
Numeric OIDNameModule
1isoLANART-AGENT
1.3orgAirPair-MIB
1.3.6dodAirPair-MIB
1.3.6.1internetAirPair-MIB
1.3.6.1.4privateAirPair-MIB
1.3.6.1.4.1enterprisesAirPair-MIB
1.3.6.1.4.1.1795pdynPDN-HEADER-MIB
1.3.6.1.4.1.1795.2pdn_mgmtPDN-HEADER-MIB
1.3.6.1.4.1.1795.2.24paradynePDN-HEADER-MIB
1.3.6.1.4.1.1795.2.24.12pdn_mpePDN-HEADER-MIB
1.3.6.1.4.1.1795.2.24.12.7mpe_devHealthPDN-HEADER-MIB
Numeric OIDNameModule
1.3.6.1.4.1.1795.2.24.12.7.1mpeDevHealthAndStatusMIBObjectsPDN-MPE-HEALTH-AND-STATUS-MIB
1.3.6.1.4.1.1795.2.24.12.7.1.1mpeDevHealthAndStatusTablePDN-MPE-HEALTH-AND-STATUS-MIB
1.3.6.1.4.1.1795.2.24.12.7.1.1.1mpeDevHealthAndStatusEntryPDN-MPE-HEALTH-AND-STATUS-MIB
1.3.6.1.4.1.1795.2.24.12.7.1.1.1.1mpeDevSelfTestResultsPDN-MPE-HEALTH-AND-STATUS-MIB