All MIBs › ONEACCESS-VRF-TO-IF-MIB
Organization: ONE ACCESS
Last Updated: 2012-04-05
Category: CPE/Router
Description: Maps VPN routing and forwarding (VRF) instances to physical and logical interfaces on OneAccess CPE routers.
Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.
What Is ONEACCESS-VRF-TO-IF-MIB?
ONEACCESS-VRF-TO-IF-MIB is a vendor-specific SNMP module from OneAccess that maps VPN routing and forwarding (VRF) instances to the physical and logical interfaces attached to them on OneAccess CPE routers. It is a configuration/topology-mapping MIB rather than a hardware or performance monitoring one, listing which interfaces belong to which configured VRF for multi-tenant or MPLS VPN routing setups. Its monitoring relevance is limited to confirming correct VRF-to-interface associations, which is useful for verifying that a router's VPN routing configuration matches intent, rather than reporting hardware faults or performance counters. It necessarily depends on the router's core VRF/routing configuration and on standard interface indexing conventions (such as IF-MIB) to identify the interfaces involved. It is used in enterprise or service-provider deployments where OneAccess routers participate in MPLS VPNs or other VRF-based multi-tenant routing architectures. Engineers can download the ONEACCESS-VRF-TO-IF-MIB file directly to load it into their MIB browser.
IPNetwork Monitor allows you to monitor SNMP objects defined in ONEACCESS-VRF-TO-IF-MIB. Use the built-in SNMP Monitoring Browser to explore available variables, view their current values and descriptions, and select the objects you want to monitor. You can then create SNMP monitors, configure thresholds, and receive alerts when monitored values change.
Supported Devices
- OneAccess (now Ekinops) CPE routers running ONEOS
Monitoring Examples
No sample objects were provided for this module, so specific object or table names cannot be cited. Based on its description, one would expect a table mapping each VRF name to a list of attached interface indexes, letting an administrator confirm which physical or logical interfaces are bound to a given VRF. An operator might use this to verify that a newly configured VRF has picked up the correct interface after a configuration change, catching a misconfiguration where an interface was left in the wrong VRF. Without concrete object names, this remains a general rather than object-grounded description.
Imported Objects
From IF-MIB
| ifIndex | OBJECT-TYPE |
From ONEACCESS-GLOBAL-REG
| oacExpIMIp | OBJECT-IDENTITY |
From SNMPv2-SMI
| MODULE-IDENTITY | |
| OBJECT-TYPE |
From SNMPv2-TC
| TEXTUAL-CONVENTION |
OIDs
RFC description
Maps Virtual Routing and Forwarding (VRF) instances to interfaces on OneAccess routing devices.
Start monitoring OneAccess CPE routers with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.