Description: The minimum dimensions supported by this output sub-unit for measurements taken ninety degrees relative to the feed direction associated with that sub-unit in output sub-unit dimensional units (DimUnit). If this output sub-unit can reliably sense this value, the value is sensed by the printer and may not be changed with management protocol operations. Refer to Internet Draft Printer MIB, expiring Sept. 1997 for more details. Additional information: LaserJet Series 4000 has two output bins in the base product: a face-up bin on the back of the engine and a face-down bin on the top of the engine. These bins are not firmware-selectable; instead, paper is diverted to the face-down bin only if the face-up bin is physically closed. Therefore, these bins are considered together as the 'standard' bin. The value returned by this object depends on the value of prtOutputDimUnit. It is 30000 if prtOutputDimUnit is ePtenThousandthsOfInches or 76200 if prtOutputDimUnit is ePmicrometers.