Select a Juniper WX series WAN optimization appliance as the target host to create a monitor — the SNMP service should be up and running on it. Click New Monitor, then check SNMP Custom on the Favorites tab, click Next, and confirm the host. On the next page, click Select... to open the built-in SNMP MIB Browser and type jnxWxStatsAsmCount into the Find box to locate it in the OID tree, then select it and click OK. It reports the number of distinct decompressor peers this compressor has had a session with over the last two months. On the monitor's Main parameters page you can set the target's SNMP port (default 161), credentials, polling interval, and other settings — see the SNMP Monitor help for details. On the State conditions and Alerting tabs, configure when the monitor should change state and trigger an alert; since this is an Integer32-type OID, Value bounds is the most useful condition here — trigger an alert if the count changes noticeably from its expected baseline, since a sudden change in peer count often reflects a topology or connectivity shift. Click Finish to create the monitor; you can adjust any parameter later.