Description: This is the command/status value for the APS Status Row. The value used in a SET will be replaced by a response value in the GET RESPONSE indicating success or failure. These commands can only be SET in the Working APS Device.

Default Response State used in GET RESPONSE Command readyForRequest (0) initial default status for a row

APS Requests used in SET Command (1..99) manualSwitchReq (8) Manually Switches the specified working device to the protection device. forceSwitchReq (14) Switches the specified working device to the protection device. clearRequest (31) Clears all of the switch commands for the specified APS device.

Response States used in GET RESPONSE Command (100..199) manual-successful (108) Manual Switch command has been successfully processed force-successful (114) Forced Switch command has been successfully processed clear-successful (131) Switch commands been successfully cleared

Error Codes used in GET RESPONSE Command (400..799) err-gen-aps-req-error (400) Unknown APS request error occurred err-invalid-aps-card-type (402) Requests cannot be processed by the protection card err-field-cannot-be-set (406) Read-only field was included in SET request err-invalid-aps-command (408) Invalid APS request err-snmp-parse-failed (500) Agent could not parse variable err-invalid-snmp-type (501) Variable ASN type does not match Agent defined type err-invalid-snmp-var-size (502) Variable size is too big