Select a Calix E5-120 multi-service access platform as the target host to create a monitor — the SNMP service should be up and running on it. Click New Monitor, then check SNMP Custom on the Favorites tab, click Next, and confirm the host. On the next page, click Select... to open the built-in SNMP MIB Browser and locate seltLoopEstimateLengthFt under the selt branch of E5-120-MIB, then select it and click OK. It reports, in feet, the copper loop length estimated by the Single-Ended Line Test (SELT) diagnostic for this subscriber line. On the monitor's Main parameters page you can set the target's SNMP port (default 161), credentials, polling interval, and other settings — see the SNMP Monitor help for details. On the State conditions and Alerting tabs, configure when the monitor should change state and trigger an alert; since this is an INTEGER-type OID, Value bounds is the most useful condition here — trigger an alert if the estimated length changes significantly from its known baseline, which can indicate a wiring fault or an unauthorized line change. Click Finish to create the monitor; you can adjust any parameter later.