DLINK-SYSLOG-MIB

Description: Manages system logging configuration, remote syslog server settings, and log severity filtering on D-Link devices.

Start monitoring vendor-neutral, standards-based MIB, any SNMPv3-capable network device (SNMP engine identity/boot/clock status) with a free 30-day trial of IPNetwork Monitor. Import MIBs, browse SNMP OIDs, create custom SNMP monitors, configure alerts, and monitor any SNMP-enabled network device from a single console.

DLINK-SYSLOG-MIB is a D-Link proprietary MIB that manages the system logging (syslog) subsystem on D-Link switches and routers, covering remote syslog server configuration and log-severity filtering. It exposes configuration data for where log messages are sent (remote syslog server addresses) and which severity levels are forwarded, rather than the log contents themselves. Its monitoring/status value is primarily about confirming the device's own logging pipeline is correctly configured and operating — verifying a device is pointed at the intended syslog collector and that the severity filter isn't silently dropping important messages is important software-status assurance, since a broken syslog config means fault events elsewhere on the device may go unnoticed. It builds on the general "Structure of System Log Information" concept referenced in its own description, aligning conceptually with common syslog MIB patterns used across other switch vendors, though as a proprietary D-Link module rather than a cross-vendor standard. It is typically deployed on D-Link managed switches and routers in small-to-medium business networks where centralized syslog collection is used for troubleshooting and compliance logging. Engineers can download the DLINK-SYSLOG-MIB file directly to load it into their MIB browser.

No concrete sample object names were available for this MIB, so specific table/object names cannot be quoted; however, based on its description an operator would check the configured remote syslog server address(es) and severity filter level to confirm log messages from a given switch are actually reaching the central syslog collector, and would investigate a device that stops appearing in log aggregation if its syslog server configuration was found blank or pointed at an unreachable host.

D-Link system logging configuration and management for network syslog server integration.