Description: Indicates the status of a failed connection. The value of this object is only valid between attempts to establish the route connection atmDxiSRRouteState = notConnected), and may or may not change after successive failed attempts.

Options: noFailure (1): Once a system route has been successfully connected, this value is maintained for the duration of the connection.

internalError (2): An internal error has occurred.

localAllocFailure (3): There is insufficient memory available for ATM DXI to establish this connection.

remoteAllocFailure (4): There is insufficient memory available for the destination protocol layer to establish this connection.

localNoAccess (5): This route is associated with a SAP that does not exist.

remoteNoAccess (6): This route is associated with a SAP that does not exist at the destination layer.

remotePvcDown (8): The PVC at the destination protocol layer is down.

remotePvcBusy (10): The destination associated with this route is already connected. This typically occurs when the route is a non-MPE (PVC consolidating) circuit.

localFcnFailure (11): Flow control negotiation failed.

remoteFcnFailure (12): Flow control negotiation failed at the destination protocol layer.

localDsnFailure (13): Data size negotiation failed.

remoteAliasNotFound (15): The destination alias (atmDxiSRDestAlias) does not exist.

remoteNoPvcService (16): The destination protocol layer does not support PVC service.

mpeInvalidSubref (17): The value of atmDxiSRSubRef is invalid at the destination protocol layer. (i.e., atmDxiSRSubRef is set to '0' and the destination circuit is configured for PVC consolidation).

routeStalled (18): An invalid control packet exchange has occurred during the route setup procedure. The route is temporarily stalled but will recover within 5 seconds.