CISCO-WIRELESS-IF-MIB :: cwrArqMinBitRate

MIB Reference — IPNetwork Monitor · Updated September 14, 2026

All MIBsCISCO-WIRELESS-IF-MIBcwrArqMinBitRate

cwrArqMinBitRate

Module: CISCO-WIRELESS-IF-MIB

OID (symbolic): CISCO-WIRELESS-IF-MIB::cwrArqMinBitRate

OID (numeric): 1.3.6.1.4.1.9.9.136.1.4.1.1.6

Node type: OBJECT-TYPE

Type: Integer32

Access: read-only

Description: This object specifies the minimum error free bit rate that is supported on this link given the current configuration as specified in the cwrRadioPhyTable and the settings in this table.

What is cwrArqMinBitRate?

This read-only Integer32, in bits/sec, up to 45,000,000, specifies the minimum error-free bit rate the link is guaranteed to support given the current PHY configuration and ARQ table settings. It gives an admin a worst-case throughput floor to plan capacity around, distinct from the typical rate reported by cwrArqTypicalBitRate. For example, an admin sizing an application's bandwidth needs against this link would use cwrArqMinBitRate as the conservative, guaranteed-available figure rather than the typical rate.

Examples

Walk all instances (SNMPv2c):

snmpwalk -v2c -c public <target> 1.3.6.1.4.1.9.9.136.1.4.1.1.6
snmpwalk -v2c -c public <target> CISCO-WIRELESS-IF-MIB::cwrArqMinBitRate

Get a specific instance (index 1):

snmpget -v2c -c public <target> 1.3.6.1.4.1.9.9.136.1.4.1.1.6.1
snmpget -v2c -c public <target> CISCO-WIRELESS-IF-MIB::cwrArqMinBitRate.1

SNMPv3 example:

snmpget -v3 -l authPriv -u snmpv3-user -a SHA -A "AuthPassword1" -x AES -X "PrivPassword1" <target> cwrArqMinBitRate.1

Start monitoring Cisco wireless point-to-point radio/bridge equipment (legacy) with a free 30-day trial of IPNetwork Monitor. Create custom SNMP monitor using the CISCO-WIRELESS-IF-MIB::cwrArqMinBitRate OID value, configure state conditions and alerts, and monitor any Cisco wireless point-to-point radio/bridge equipment (legacy) from a single console.

OID Breakdown

Upper-level ancestors (8 from the standard OID tree / other modules)
Numeric OIDNameModule
1isoLANART-AGENT
1.3orgAirPair-MIB
1.3.6dodAirPair-MIB
1.3.6.1internetAirPair-MIB
1.3.6.1.4privateAirPair-MIB
1.3.6.1.4.1enterprisesAirPair-MIB
1.3.6.1.4.1.9ciscoCAT2600-MIB
1.3.6.1.4.1.9.9ciscoMgmtCISCO-SMI
Numeric OIDNameModule
1.3.6.1.4.1.9.9.136ciscoWirelessIfMIBCISCO-WIRELESS-IF-MIB
1.3.6.1.4.1.9.9.136.1cwrRadioMibObjectsCISCO-WIRELESS-IF-MIB
1.3.6.1.4.1.9.9.136.1.4cwrRadioPhyQualityGroupCISCO-WIRELESS-IF-MIB
1.3.6.1.4.1.9.9.136.1.4.1cwrPhyQualityTableCISCO-WIRELESS-IF-MIB
1.3.6.1.4.1.9.9.136.1.4.1.1cwrPhyQualityEntryCISCO-WIRELESS-IF-MIB
1.3.6.1.4.1.9.9.136.1.4.1.1.6cwrArqMinBitRateCISCO-WIRELESS-IF-MIB