Description: Indicates the state of the IMA port. The following error conditions are currently reported: 1 - Unconfigured state 2 - Active state 3 - Bandwidth changed due to addition/deletion of links. The addition/deletion can be triggered by either end 4 - FailedDueToACPTimeout (indicates that a timeout occurred due to non-arrival of an ACP cell) 5 - FailedDueToMajorAlarmOnIMAGroup (issued when the bandwidth of an IMA group falls below a certain threshold due to loss of links from an IMA group) 6 - FailedDueToImaSigFailure (this indicates configuration mismatch or non-arrival of LCP cells during set up of an IMA group) 7 - FailedDueToBadDiffDelay (indicates that the differential delay exceeded the maximum threshold) 8 - FailedDueToArbConflict (indicates that the IMA-ID could not be resolved between the 2 ends of the IMA pipe) 9 - Receiving Local OAM AIS from peer IMA node (valid only for network modules) 10- Receiving LOAM RDI from peer IMA node (valud only for network modules) 20- Failed due to ILMI signalling failure This object does not have any default value