All MIBs › CISCO-LWAPP-WLAN-MIB › cLWlanScanDeferTime
cLWlanScanDeferTime
Module: CISCO-LWAPP-WLAN-MIB
OID (symbolic): CISCO-LWAPP-WLAN-MIB::cLWlanScanDeferTime
OID (numeric): 1.3.6.1.4.1.9.9.512.1.1.1.1.24
Node type: OBJECT-TYPE
Type: Unsigned32
Access: read-create
Description:
This object specifies the minimum number of milliseconds that must elapse without the appearance of a specified packet before the access point radios begin an off-channel scan.
What is cLWlanScanDeferTime?
This read-create object on Cisco LWAPP controllers specifies the minimum milliseconds of quiet time required before radio access points initiate an off-channel scan. Operators tune it to balance channel scanning frequency against the need to minimize time off the primary channel. Higher values reduce overhead but delay detection of better candidate channels for roaming clients.
OID Breakdown
| Numeric OID | Name | Module |
|---|---|---|
| 1 | iso | LANART-AGENT |
| 1.3 | org | BIANCA-BRICK-PPP-MIB |
| 1.3.6 | dod | BIANCA-BRICK-PPP-MIB |
| 1.3.6.1 | internet | BIANCA-BRICK-PPP-MIB |
| 1.3.6.1.4 | private | BIANCA-BRICK-PPP-MIB |
| 1.3.6.1.4.1 | enterprises | ANIROOT-MIB |
| 1.3.6.1.4.1.9 | cisco | CISCO-SMI |
| 1.3.6.1.4.1.9.9 | ciscoMgmt | CISCO-SMI |
| 1.3.6.1.4.1.9.9.512 | ciscoLwappWlanMIB | CISCO-LWAPP-WLAN-MIB |
| 1.3.6.1.4.1.9.9.512.1 | ciscoLwappWlanMIBObjects | CISCO-LWAPP-WLAN-MIB |
| 1.3.6.1.4.1.9.9.512.1.1 | ciscoLwappWlanConfig | CISCO-LWAPP-WLAN-MIB |
| 1.3.6.1.4.1.9.9.512.1.1.1 | cLWlanConfigTable | CISCO-LWAPP-WLAN-MIB |
| 1.3.6.1.4.1.9.9.512.1.1.1.1 | cLWlanConfigEntry | CISCO-LWAPP-WLAN-MIB |
| 1.3.6.1.4.1.9.9.512.1.1.1.1.24 | cLWlanScanDeferTime | CISCO-LWAPP-WLAN-MIB |