CISCO-LWAPP-AP-MIB :: cLApLastRebootReason

MIB Reference — IPNetwork Monitor · Updated September 14, 2026

All MIBsCISCO-LWAPP-AP-MIBcLApLastRebootReason

cLApLastRebootReason

Module: CISCO-LWAPP-AP-MIB

OID (symbolic): CISCO-LWAPP-AP-MIB::cLApLastRebootReason

OID (numeric): 1.3.6.1.4.1.9.9.513.1.1.1.1.16

Node type: OBJECT-TYPE

Type: INTEGER

Access: read-only

Description: This object represents the reason for the last reboot of the AP. none - ap reported a reboot reason code unknown to the controller. dot11gModeChange - 11g mode change ipAddressSet - set static ip address ipAddressReset - reset static ip address rebootFromController - ap reboot initiated from controller dhcpFallbackFail - could not fallback to dhcp discoveryFail - could not send discovery noJoinResponse - did not receive join response denyJoin - deny join attempt at the controller noConfigResponse - did not get config response configController - found configured or master controller imageUpgradeSuccess - image upgraded successfully imageOpcodeInvalid - invalid image data opcode imageCheckSumInvalid - invalid image md5 checksum imageDataTimeout - image data message timeout configFileInvalid - invalid config file imageDownloadError - image download process error rebootFromConsole - reboot command from ap console rapOverAir - root access point is connected over the air brownout - ap rebooted due to power failure powerLow - ap rebooted dued to low power also called as brownout crash - crashed due to software failure powerHigh - rebooted due to power spike powerLoss - rebooted due to power loss powerChange - rebooted due to change in power source componentFailure - rebooted due to component failure watchdog - rebooted due to watch dog timer reset.

What is cLApLastRebootReason?

Reports the reason code for the access point's most recent reboot, such as an 11g mode change or a static IP address being set, as reported by the AP to the controller.

Examples

Walk all instances (SNMPv2c):

snmpwalk -v2c -c public <target> 1.3.6.1.4.1.9.9.513.1.1.1.1.16
snmpwalk -v2c -c public <target> CISCO-LWAPP-AP-MIB::cLApLastRebootReason

Get a specific instance (index 1):

snmpget -v2c -c public <target> 1.3.6.1.4.1.9.9.513.1.1.1.1.16.1
snmpget -v2c -c public <target> CISCO-LWAPP-AP-MIB::cLApLastRebootReason.1

Start monitoring Cisco Wireless LAN Controllers (LWAPP-based) with a free 30-day trial of IPNetwork Monitor. Create custom SNMP monitor using the CISCO-LWAPP-AP-MIB::cLApLastRebootReason OID value, configure state conditions and alerts, and monitor any Cisco Wireless LAN Controllers (LWAPP-based) from a single console.

OID Breakdown

Upper-level ancestors (8 from the standard OID tree / other modules)
Numeric OIDNameModule
1isoLANART-AGENT
1.3orgAirPair-MIB
1.3.6dodAirPair-MIB
1.3.6.1internetAirPair-MIB
1.3.6.1.4privateAirPair-MIB
1.3.6.1.4.1enterprisesAirPair-MIB
1.3.6.1.4.1.9ciscoCAT2600-MIB
1.3.6.1.4.1.9.9ciscoMgmtCISCO-SMI
Numeric OIDNameModule
1.3.6.1.4.1.9.9.513ciscoLwappApMIBCISCO-LWAPP-AP-MIB
1.3.6.1.4.1.9.9.513.1ciscoLwappApMIBObjectsCISCO-LWAPP-AP-MIB
1.3.6.1.4.1.9.9.513.1.1ciscoLwappApCISCO-LWAPP-AP-MIB
1.3.6.1.4.1.9.9.513.1.1.1cLApTableCISCO-LWAPP-AP-MIB
1.3.6.1.4.1.9.9.513.1.1.1.1cLApEntryCISCO-LWAPP-AP-MIB
1.3.6.1.4.1.9.9.513.1.1.1.1.16cLApLastRebootReasonCISCO-LWAPP-AP-MIB