Description: An entry for each device credential export action that is being executed or was executed recently. The management application triggers the export by creating an entry in this table. This can be done in the following 2 methods

1. CREATE-AND-GO method Management application sets clmgmtDevCredExportActionStatus to createAndGo(4) and all other required objects to valid values in a single SNMP SET request. If all the values are valid, the device creates the entry and executes the action. If the SET request fails, the entry will not be created. 2. CREATE-AND-WAIT method Management application sets clmgmtDevCredExportActionStatus to createAndWait(5) to create an entry. Management application can set all other required objects to valid values in more than one SNMP SET request. If SET request for any of the objects fails, management application can set just only that object. Once all the required objects are set to valid values, management application triggers action execution by setting clmgmtDevCredExportActionStatus to active(1).

To stop the action from being executed, the management application can delete the entry by setting clmgmtDevCredExportActionStatus to destroy(6) when clmgmtDevCredCommandState is pending(2).

The status of action execution can be known by querying clmgmtDevCredCommandState. If the action is still in pending(2) or inProgress(3), the management application need to check back again after few seconds. Once the action completes and if status of the action is failed(6), the reason for failure can be retrieved from clmgmtDevCredCommandFailCause.

Entry can be deleted except when clmgmtLicenseAction is set to inProgress(3). All entries in this table are volatile and are cleared on agent reset.