Description: This is the time in seconds over which Redundant Gigabit Ethernet Input Transport Stream Pairs will be monitored. Range is 1 to 30 seconds.

Primary to Secondary Fail Over - The monitored data rate of the Primary must be below the Secondary by apexManRteGbeInRedThreshold (for Manual Routing) percent for apexGbeConfInRedundMonitorPeriod before fail over to Secondary will occur. Fail over to Secondary will not occur if fail over is suspended for the Primary.

Secondary to Primary Switch Back - The monitored data rate of the Primary must have returned above apexManRteGbeInRedThreshold (for Manual Routing) percent below the Secondary for apexGbeConfInRedundMonitorPeriod before switch back to Primary will occur. Switch back to Primary will not occur if fail over is suspended for the Secondary. Once the Primary is restored, switch back to Primary will be delayed by apexGbeConfInRedundSwitchTime when apexGbeConfInRedundAutoSwitchBack is 'enabled'. Note that if apexGbeConfInRedundAutoSwitchBack is 'disabled' switch back will not occur.

Once written, the change to this parameter will take immediate effect. However, in order for the change to persist through subsequent reboots or power cycles, the change must be saved via apexSaveConfig.

@Config(config=yes, reboot=no) @Save(apexSaveConfig, value=2) @File(gige_red.ini, type='ini')