Description: The zxr10MplsTunnelARHopTable is used to indicate the hops for an MPLS tunnel defined in zxr10MplsTunnelTable, as reported by the MPLS signalling protocol. Thus at a transit LSR, this table (if the table is supported and if the signaling protocol is recording actual route information) contains the actual route of the whole tunnel. If the signaling protocol is not recording the actual route, this table MAY report the information from the zxr10MplsTunnelHopTable or the zxr10MplsTunnelCHopTable. Each row in this table is indexed by zxr10MplsTunnelARHopListIndex. Each row also has a secondary index zxr10MplsTunnelARHopIndex, corresponding to the next hop that this row corresponds to. Please note that since the information necessary to build entries within this table is not provided by some MPLS signalling protocols, implementation of this table is optional. Furthermore, since the information in this table is actually provided by the MPLS signalling protocol after the path has been set-up, the entries in this table are provided only for observation, and hence, all variables in this table are accessible exclusively as readonly. Note also that the contents of this table may change while it is being read because of re-routing activities. A network administrator may verify that the actual route read is consistent by reference to the zxr10MplsTunnelLastPathChange object.