All MIBs › MPLS-TE-MIB › mplsTunnelARHopAddrType
mplsTunnelARHopAddrType
Module: MPLS-TE-MIB
OID (symbolic): MPLS-TE-MIB::mplsTunnelARHopAddrType
OID (numeric): 1.3.6.1.3.95.2.7.1.3
Node type: OBJECT-TYPE
Type: INTEGER
Access: read-only
Description: Denotes the address type of this tunnel hop.
What is mplsTunnelARHopAddrType?
Reports which address format (IPv4, IPv6, or AS number) describes this actual-route hop as reported back by the signaling protocol after the tunnel was set up; this table is read-only since it reflects what actually happened rather than what was requested.
Examples
Walk all instances (SNMPv2c):
snmpwalk -v2c -c public <target> 1.3.6.1.3.95.2.7.1.3 snmpwalk -v2c -c public <target> MPLS-TE-MIB::mplsTunnelARHopAddrType
Get a specific instance (index 1):
snmpget -v2c -c public <target> 1.3.6.1.3.95.2.7.1.3.1 snmpget -v2c -c public <target> MPLS-TE-MIB::mplsTunnelARHopAddrType.1
Start monitoring Vendor-neutral IETF standard (MPLS-enabled provider-edge/core router, Traffic Engineering) with a free 30-day trial of IPNetwork Monitor. Create custom SNMP monitor using the MPLS-TE-MIB::mplsTunnelARHopAddrType OID value, configure state conditions and alerts, and monitor any Vendor-neutral IETF standard (MPLS-enabled provider-edge/core router, Traffic Engineering) from a single console.
OID Breakdown
Upper-level ancestors (5 from the standard OID tree / other modules)
| Numeric OID | Name | Module |
|---|---|---|
| 1 | iso | LANART-AGENT |
| 1.3 | org | AirPair-MIB |
| 1.3.6 | dod | AirPair-MIB |
| 1.3.6.1 | internet | AirPair-MIB |
| 1.3.6.1.3 | experimental | AXON-MIB |
| Numeric OID | Name | Module |
|---|---|---|
| 1.3.6.1.3.95 | mplsTeMIB | MPLS-TE-MIB |
| 1.3.6.1.3.95.2 | mplsTeObjects | MPLS-TE-MIB |
| 1.3.6.1.3.95.2.7 | mplsTunnelARHopTable | MPLS-TE-MIB |
| 1.3.6.1.3.95.2.7.1 | mplsTunnelARHopEntry | MPLS-TE-MIB |
| 1.3.6.1.3.95.2.7.1.3 | mplsTunnelARHopAddrType | MPLS-TE-MIB |