Description: Setting this table causes RIP to taylor its update announcements. This table allows the network administrator to limit RIP's scope for outbound processing. Inbound processing is not affected by this table. If the rRipAnncType is set to ANNOUNCE, RIP will adjust its outbound announcments on the indicated (sub)network by propogating announcements for those gateways listed in the rRipAnncTable only. All announcements for gateways not on the ANNOUNCE list will not be sent over the associated (sub)network. If the rRipAnncType is set to DO-NOT-ANNOUNCE, RIP will adjust its outbound announcements on the indicated (sub)network by not propogating announcements for those gateways listed in the rRipAnncTable. All other announcements will be propogated on the indicated (sub)network. If the value of ripAnncType is changed, this table is cleared. This table is maintained on a per (sub)network basis. If the table is empty, it is assumed that all gateways on all (sub)networks are ANNOUNCE. This is also the default state. To change the state of an entry from ANNOUNCE to DO-NOT-ANNOUNCE or vice versa, change the rRipAnncType in the ripAnncIndTable for the (sub)network and then define the new restriction list for the (sub)network. Please note that before any entries can be defined here or in the rRipAnncIndTable, the (sub)network must be defined to the router via an ipAddrEntry.