Description: Current operational status of the module. This value is the same as swPortStatus for the corresponding switched port. Possible values are: enabled : normal operation (transmit and receive) disabled-mgmt : disabled by explicit management action suspended-linkbeat : suspended due to absence of linkbeat suspended-jabber : suspended because port is jabbering suspended-violation : suspended due to a secured address violation disabled-violation : disabled due to a secured address violation suspended-not-present: there is no module inserted in the expansion slot. suspended-not-recognized: there is an unrecognized module inserted in the expansion slot. reset : the module is currently in the reset state suspended-ringdown : suspended due to a ring-down condition suspended-stp : Spanning Tree Protocol non forwarding state disabled-self-test : disabled because port fails self-test suspended-atm-lane-down: Non-trunk ATM module using LANE suspended because there is no active LANE client. suspended-no-vlan : the module is not assigned to a VLAN or the assigned VLAN does not exist. disabled-no-vlan : vlan of the module is suspended or does not exist. suspended-atm-network-down: ATM module suspended due to ATM network down, or ATM physical layer down. suspended-disl : suspended while module is negotiating trunking mode using the Dynamic Inter Switch Link protocol.

The default value is enabled(1), unless POST has detected a failure on the module switch port, in which case, it is disabled-mgmt(2). Any esModuleStatus of type disabled-xxxx (except disabled-self-test) is saved across a system reset so a module may also come up with such a status.