Description: The command status for this link configuration row/record. The value used in a SET will be replaced by a response value in the GET RESPONSE indicating success or failure.

Default Response State used in GET RESPONSE Command ready-for-command (0) initial default status for a row

T3 Link Commands used in SET Command (1..99) update-link-config(1), Change existing Link Configuration

Response States used in GET RESPONSE Command (100..199) update-successful (101) Link data has been successfully changed

T3 Port Config Error Codes used in GET RESPONSE Command (100..699) err-general-link-config-error (400) Unknown link configuration error occurred err-invalid-link-status (401) Unrecognized link status setting err-invalid-link-framing (402) Line framing type not valid for link type err-invalid-link-command (403) Unrecognized link command-action err-invalid-link-op-mode (407) Configured M13 Op mode not valid for port; verify other link parameters match desired new mode err-invalid-link-rem-loop (408) Remote Loop type not valid for t3 frame type err-invalid-link-ais (409) Unrecognized t3 AIS selection err-data-locked-by-another-user (450) Another administrative user is making changes to this part of the system via a terminal session. Check Event Log for user name err-snmp-parse-failed (500) Agent could not parse variable err-invalid-snmp-type (501) Variable ASN type does not match Agent defined type err-invalid-snmp-var-size (502) Variable size is too big