All MIBs › DOCS-QOS-MIB › docsQosParamSetNomPollInterval
docsQosParamSetNomPollInterval
Module: DOCS-QOS-MIB
OID (symbolic): DOCS-QOS-MIB::docsQosParamSetNomPollInterval
OID (numeric): 1.3.6.1.2.1.10.127.7.1.2.1.15
Node type: OBJECT-TYPE
Type: Unsigned32
Access: read-only
Description: Specifies the nominal interval in microseconds between successive unicast request opportunities on an upstream service flow.
This object applies only to upstream service flows with schedulingType of value nonRealTimePollingService(3), realTimePollingService(4), and unsolictedGrantServiceWithAD(5). The parameter is mandatory for realTimePollingService(4). If the parameter is omitted with nonRealTimePollingService(3), the CMTS uses an implementation dependent value. If the parameter is omitted with unsolictedGrantServiceWithAD(5), the CMTS uses as a default value the value of the Nominal Grant Interval parameter. In all cases, the CMTS reports the value it is using when the parameter is applicable. The CM reports the signaled parameter value if it was signaled, and 0 otherwise.
If the referenced parameter is not applicable to the direction or scheduling type of the corresponding DOCSIS QOS Parameter Set, both CMTS and CM report this object's value as 0.
Examples
Walk all instances (SNMPv2c):
snmpwalk -v2c -c public <target> 1.3.6.1.2.1.10.127.7.1.2.1.15 snmpwalk -v2c -c public <target> DOCS-QOS-MIB::docsQosParamSetNomPollInterval
Get a specific instance (index 1):
snmpget -v2c -c public <target> 1.3.6.1.2.1.10.127.7.1.2.1.15.1 snmpget -v2c -c public <target> DOCS-QOS-MIB::docsQosParamSetNomPollInterval.1
Start monitoring DOCSIS 1.1/2.0 cable modem/CMTS (QoS, vendor-neutral IETF/CableLabs standard) with a free 30-day trial of IPNetwork Monitor. Create custom SNMP monitor using the DOCS-QOS-MIB::docsQosParamSetNomPollInterval OID value, configure state conditions and alerts, and monitor any DOCSIS 1.1/2.0 cable modem/CMTS (QoS, vendor-neutral IETF/CableLabs standard) from a single console.
OID Breakdown
Upper-level ancestors (8 from the standard OID tree / other modules)
| Numeric OID | Name | Module |
|---|---|---|
| 1 | iso | LANART-AGENT |
| 1.3 | org | AirPair-MIB |
| 1.3.6 | dod | AirPair-MIB |
| 1.3.6.1 | internet | AirPair-MIB |
| 1.3.6.1.2 | mgmt | AXON-MIB |
| 1.3.6.1.2.1 | mib_2 | AXON-MIB |
| 1.3.6.1.2.1.10 | transmission | CHECKPOINT-MIB-2 |
| 1.3.6.1.2.1.10.127 | docsIfMib | DOCS-IETF-RFI-MIB |
| Numeric OID | Name | Module |
|---|---|---|
| 1.3.6.1.2.1.10.127.7 | docsQosMIB | DOCS-QOS-MIB |
| 1.3.6.1.2.1.10.127.7.1 | docsQosMIBObjects | DOCS-QOS-MIB |
| 1.3.6.1.2.1.10.127.7.1.2 | docsQosParamSetTable | DOCS-QOS-MIB |
| 1.3.6.1.2.1.10.127.7.1.2.1 | docsQosParamSetEntry | DOCS-QOS-MIB |
| 1.3.6.1.2.1.10.127.7.1.2.1.15 | docsQosParamSetNomPollInterval | DOCS-QOS-MIB |