Select a Cisco switches (e.g. Catalyst series) in a management cluster (legacy) as the target host to create a monitor — the SNMP service should be up and running on it. Click New Monitor, then check SNMP Custom on the Favorites tab, click Next, and confirm the host. On the next page, click Select... to open the built-in SNMP MIB Browser and type ccStatusClusterMode into the Find box to locate it in the OID tree, then select it and click OK. The mode of the device. A device can become a member switch only when it is added to the cluster at the command switch. On the monitor's Main parameters page you can set the target's SNMP port (default 161), credentials, polling interval, and other settings — see the SNMP Monitor help for details. On the State conditions and Alerting tabs, configure when the monitor should change state and trigger an alert; since this is an INTEGER-type OID, Value bounds is the most useful condition here — trigger an alert if the value changes unexpectedly, since which mode is correct for this device depends on your cluster topology and an unplanned change often indicates a fault or misconfiguration. Click Finish to create the monitor; you can adjust any parameter later.