CAMBIUM-PTP600-MIB :: ethernetCappedMaxWirelessSpeed

MIB Reference — IPNetwork Monitor · Updated September 14, 2026

All MIBsCAMBIUM-PTP600-MIBethernetCappedMaxWirelessSpeed

ethernetCappedMaxWirelessSpeed

Module: CAMBIUM-PTP600-MIB

OID (symbolic): CAMBIUM-PTP600-MIB::ethernetCappedMaxWirelessSpeed

OID (numeric): 1.3.6.1.4.1.17713.6.5.10

Node type: OBJECT-TYPE

Type: INTEGER

Access: read-write

Description: Ethernet frames will be discarded in the ODU if the data rate over the wireless link exceeds the Ethernet link speed at the local or remote Data port. The Ethernet Capped Max Wireless Speed control limits the wireless data rate based on the local and remote Ethernet link speed. Set this control to Enabled if either ODU is connected to an Ethernet link operating at less than 1000 Mbps. NB: This attribute is automatically disabled when the installation agent is armed. To disarm the installation agent use the installation wizard.

What is ethernetCappedMaxWirelessSpeed?

This setting limits the wireless link's data rate to match the slower of the local and remote Ethernet port speeds, since frames would otherwise be discarded in the radio unit if the wireless rate exceeds the Ethernet link speed. An admin should enable it whenever either end's Ethernet port runs below 1000 Mbps; note it is automatically disabled while the installation agent is armed.

Examples

Walk all instances (SNMPv2c):

snmpwalk -v2c -c public <target> 1.3.6.1.4.1.17713.6.5.10
snmpwalk -v2c -c public <target> CAMBIUM-PTP600-MIB::ethernetCappedMaxWirelessSpeed

Get a specific instance (index 1):

snmpget -v2c -c public <target> 1.3.6.1.4.1.17713.6.5.10.1
snmpget -v2c -c public <target> CAMBIUM-PTP600-MIB::ethernetCappedMaxWirelessSpeed.1

Set instance 1 (SNMPv2c):

snmpset -v2c -c private <target> 1.3.6.1.4.1.17713.6.5.10.1 i <value>

Start monitoring Cambium Networks PTP-series wireless Ethernet bridge with a free 30-day trial of IPNetwork Monitor. Create custom SNMP monitor using the CAMBIUM-PTP600-MIB::ethernetCappedMaxWirelessSpeed OID value, configure state conditions and alerts, and monitor any Cambium Networks PTP-series wireless Ethernet bridge from a single console.

OID Breakdown

Upper-level ancestors (7 from the standard OID tree / other modules)
Numeric OIDNameModule
1isoLANART-AGENT
1.3orgAirPair-MIB
1.3.6dodAirPair-MIB
1.3.6.1internetAirPair-MIB
1.3.6.1.4privateAirPair-MIB
1.3.6.1.4.1enterprisesAirPair-MIB
1.3.6.1.4.1.17713cambiumCAMBIUM-PMP80211-MIB
Numeric OIDNameModule
1.3.6.1.4.1.17713.6ptp600CAMBIUM-PTP600-MIB
1.3.6.1.4.1.17713.6.5configurationCAMBIUM-PTP600-MIB
1.3.6.1.4.1.17713.6.5.10ethernetCappedMaxWirelessSpeedCAMBIUM-PTP600-MIB