Description: This object holds a pointer to a row in the appropriate table depending on the value of the atmfAtmServiceFailReason object. This will allow the network side to determine MIB information that caused the auto-configuration failure. The value of this object should be as follows: If atmfAtmServiceConfFailReason = 1 or 2, then this object's value points to the row in the atmfAtmServiceTypeTable that is the cause of the problem. If atmfAtmServiceConfFailReason = 3, then this object's value points to the row in the atmfAALxProfileTable, where x is 1, 2, 34, or 5 depending on the AAL that can't be supported. If atmfAtmServiceConfFailReason = 4, then this object's value points to the row in the atmfAtmServiceConnInfoTable that is the cause of the problem. For any other value of atmfAtmServiceConfFailReason, this object's value should be ignored.