Select a System Engineering International JuiceBox product line device (base enterprise OID registration) as the target host to create a monitor — the SNMP service should be up and running on it. Click New Monitor, then check SNMP Custom on the Favorites tab, click Next, and confirm the host. On the next page, click Select... to open the built-in SNMP MIB Browser and type juiceBoxMainSystemVoltage into the Find box to locate it in the OID tree, then select it and click OK. It reports the measured system voltage in millivolts . On the monitor's Main parameters page you can set the target's SNMP port (default 161), credentials, polling interval, and other settings — see the SNMP Monitor help for details. On the State conditions and Alerting tabs, configure when the monitor should change state and trigger an alert; since this is a Gauge32-type OID, Value bounds is the most useful condition here — trigger an alert if the value drifts significantly from its normal baseline (in milliVolts), since an unexpected change often points to a real underlying issue. Click Finish to create the monitor; you can adjust any parameter later.