All MIBs › IMA-MIB › imaGroupTestProcStatus
imaGroupTestProcStatus
Module: IMA-MIB
OID (symbolic): IMA-MIB::imaGroupTestProcStatus
OID (numeric): 1.3.6.1.4.1.353.5.7.1.1.2.1.37
Node type: OBJECT-TYPE
Type: ImaTestProcStatus
Access: read-create
Description:
This object is used to enable or disable the Test Pattern Procedure, and to note whether at least one link failed the test.
The test is started by setting operating(2) status. If any link should fail the test, the IMA will set the status to linkFail(3). The linkFail(3) state will persist until either the disabled(1) state is set or until no instance of imaLinkTestProcStatus has the value linkFail(3).
Only the values disabled(1) and operating(2) may be written. Writing the operating(2) value will not cause clearing of the linkFail(3) state.
What is imaGroupTestProcStatus?
This controls whether a link test procedure runs on an IMA (Inverse Multiplexing over ATM) group and reports pass/fail status. Setting it to operating starts the test; if any link fails, the status changes to linkFail. A technician would use this to verify that all links in a bonded ATM circuit are functioning properly.
OID Breakdown
| Numeric OID | Name | Module |
|---|---|---|
| 1 | iso | LANART-AGENT |
| 1.3 | org | BIANCA-BRICK-PPP-MIB |
| 1.3.6 | dod | BIANCA-BRICK-PPP-MIB |
| 1.3.6.1 | internet | BIANCA-BRICK-PPP-MIB |
| 1.3.6.1.4 | private | BIANCA-BRICK-PPP-MIB |
| 1.3.6.1.4.1 | enterprises | ANIROOT-MIB |
| 1.3.6.1.4.1.353 | atmForum | ATM-FORUM-SNMP-M4-MIB |
| 1.3.6.1.4.1.353.5 | atmForumNetworkManagement | ATM-FORUM-SNMP-M4-MIB |
| 1.3.6.1.4.1.353.5.7 | atmfIma | IMA-MIB |
| 1.3.6.1.4.1.353.5.7.1 | atmfImaMib | IMA-MIB |
| 1.3.6.1.4.1.353.5.7.1.1 | atmfImaMibObjects | IMA-MIB |
| 1.3.6.1.4.1.353.5.7.1.1.2 | imaGroupTable | IMA-MIB |
| 1.3.6.1.4.1.353.5.7.1.1.2.1 | imaGroupEntry | IMA-MIB |
| 1.3.6.1.4.1.353.5.7.1.1.2.1.37 | imaGroupTestProcStatus | IMA-MIB |