Description: Set with a filename to save the currently running software to the root of flash. Only one save operation can be executed at a time across all SNMP users, and the filename must not contain whitespace characters.

Immediately upon executing the set action, the actual firmware save operation will be started and continue on the device until it has completed or a failure occurs.

Subsequent reads of the object will return one of several results:

saving x A saving operation is currently in progress. Another save cannot be started while the object is returning this value.

x success The last save operation was successfully completed.

x failure: [error] The last save operation failed, due to the descriptive message attached. The most common failure is lack of disk space.

idle There is no save operation in progress and a new one may be started.

Upon reading a success or failure message, the message will be cleared and the next read will result in an 'idle' message. A new save operation can now be executed.

NOTE: This object has been replaced by objects currSoftSaveToFile, currSoftSaveStatus and currSoftLastSaveResult.