All MIBs › APS-MIB › apsConfigWaitToRestore
apsConfigWaitToRestore
Module: APS-MIB
OID (symbolic): APS-MIB::apsConfigWaitToRestore
OID (numeric): 1.3.6.1.2.1.10.49.1.1.2.1.9
Node type: OBJECT-TYPE
Type: Integer32
Access: read-create
Description: The Wait To Restore period in seconds.
After clearing of a condition that necessitated an automatic switch, the wait to restore period must elapse before reverting. This is intended to avoid rapid switch oscillations.
GR-253-CORE specifies a Wait To Restore range of 5 to 12 minutes. G.783 defines a 5 to 12 minute Wait To Restore range in section 5.4.1.1.3, but also allows for a shorter WTR period in Table 2-1, WaitToRestore value (MI_WTRtime: 0..(5)..12 minutes).
This object may not be modified if the associated apsConfigRowStatus object is equal to active(1).
What is apsConfigWaitToRestore?
Specifies the wait-to-restore interval in seconds that must elapse after a fault clears before traffic is switched back to the working line in revertive mode. This delay prevents rapid oscillation between working and protection paths when a fault condition is intermittent.
OID Breakdown
Upper-level ancestors (7 from the standard OID tree / other modules)
| Numeric OID | Name | Module |
|---|---|---|
| 1 | iso | LANART-AGENT |
| 1.3 | org | AirPair-MIB |
| 1.3.6 | dod | AirPair-MIB |
| 1.3.6.1 | internet | AirPair-MIB |
| 1.3.6.1.2 | mgmt | APERTUS-NPG-MIB |
| 1.3.6.1.2.1 | mib_2 | AXON-MIB |
| 1.3.6.1.2.1.10 | transmission | CHECKPOINT-MIB-2 |
| Numeric OID | Name | Module |
|---|---|---|
| 1.3.6.1.2.1.10.49 | apsMIB | APS-MIB |
| 1.3.6.1.2.1.10.49.1 | apsMIBObjects | APS-MIB |
| 1.3.6.1.2.1.10.49.1.1 | apsConfig | APS-MIB |
| 1.3.6.1.2.1.10.49.1.1.2 | apsConfigTable | APS-MIB |
| 1.3.6.1.2.1.10.49.1.1.2.1 | apsConfigEntry | APS-MIB |
| 1.3.6.1.2.1.10.49.1.1.2.1.9 | apsConfigWaitToRestore | APS-MIB |