All MIBs › APS-MIB › apsConfigRevert
apsConfigRevert
Module: APS-MIB
OID (symbolic): APS-MIB::apsConfigRevert
OID (numeric): 1.3.6.1.2.1.10.49.1.1.2.1.4
Node type: OBJECT-TYPE
Type: INTEGER
Access: read-create
Description: The revertive mode of the APS group.
nonrevertive
Traffic remains on the protection line until another switch request is received.
revertive
When the condition that caused a switch to the protection line has been cleared the signal is switched back to the working line. Since switching is revertive with the 1:n architecture, apsConfigRevert must be set to revertive if apsConfigMode is set to oneToN.
Switching may optionally be revertive with the 1+1 architecture.
This object may not be modified if the associated apsConfigRowStatus object is equal to active(1).
What is apsConfigRevert?
Specifies whether an APS group operates in revertive or non-revertive mode after a protection switch event. In revertive mode, traffic automatically switches back to the working line once the fault clears; in non-revertive mode, traffic remains on the protection line until explicitly switched back.
OID Breakdown
Upper-level ancestors (7 from the standard OID tree / other modules)
| Numeric OID | Name | Module |
|---|---|---|
| 1 | iso | LANART-AGENT |
| 1.3 | org | AirPair-MIB |
| 1.3.6 | dod | AirPair-MIB |
| 1.3.6.1 | internet | AirPair-MIB |
| 1.3.6.1.2 | mgmt | APERTUS-NPG-MIB |
| 1.3.6.1.2.1 | mib_2 | AXON-MIB |
| 1.3.6.1.2.1.10 | transmission | CHECKPOINT-MIB-2 |
| Numeric OID | Name | Module |
|---|---|---|
| 1.3.6.1.2.1.10.49 | apsMIB | APS-MIB |
| 1.3.6.1.2.1.10.49.1 | apsMIBObjects | APS-MIB |
| 1.3.6.1.2.1.10.49.1.1 | apsConfig | APS-MIB |
| 1.3.6.1.2.1.10.49.1.1.2 | apsConfigTable | APS-MIB |
| 1.3.6.1.2.1.10.49.1.1.2.1 | apsConfigEntry | APS-MIB |
| 1.3.6.1.2.1.10.49.1.1.2.1.4 | apsConfigRevert | APS-MIB |