Select an Extreme Networks VSP 8600 as the target host to create a monitor — the SNMP service should be up and running on it. Click New Monitor, then check SNMP Custom on the Favorites tab, click Next, and confirm the host. On the next page, click Select... to open the built-in SNMP MIB Browser and locate rcIpRsmltGlobalTableSize under the rcIpRsmltGlobal branch of RC-IP-MIB, then select it and click OK. It reports the current size of the Route SMLT (Split Multi-Link Trunking) table. On the monitor's Main parameters page you can set the target's SNMP port (default 161), credentials, polling interval, and other settings — see the SNMP Monitor help for details. On the State conditions and Alerting tabs, configure when the monitor should change state and trigger an alert; since this is an Integer32-type OID, Value bounds is the most useful condition here — trigger an alert if the table size grows well beyond its normal baseline, which can indicate route-table instability or a routing loop condition. Click Finish to create the monitor; you can adjust any parameter later.